Be sure to get the sides and the bottom as well as the top. Keys or no keys, use the damp cloth to wipe off the remaining surfaces of the keyboard. Use the cotton swabs for any tight areas that you cannot reach with the cloth. Just dip the cloth in the rubbing alcohol so that it is damp but not dripping wet or spray the cloth with the electronics cleaner. If you still have the keys attached to the board, you can use the cloth or the cotton swabs to clean them. (Be sure to plug the drain if the bowl is in the sink.) If you’ve taken the keys off of the board, you can place them in a bowl of lukewarm water and add a couple drops of dish soap for hand washing to clean them with some light scrubbing. Note: Take a picture of the keyboard before you pop the keys off or you’ll have a heck of a time trying to put them back in the right place. The larger keys, such as the space bar, are more complex in their makeup and are harder to remove and replace. Also, remove only the letter, number and “F” keys unless you are a computer hardware expert. Make sure to only take the top cover off the key (the part with the letter on it) and not to remove the base or it will be very difficult or impossible to put the key back on when you’re finished. If they don’t come off easily you are doing something wrong). You should be able to gently pry them off with a flat head screwdriver or knife. You can remove the keys and then wipe out the area between and beneath them with the rubbing alcohol or cleaning solution. The second way you can clean this area of the keyboard is a bit more thorough and is not necessary every time you clean it. Use it in a well ventilated area and always hold the can upright so it doesn’t leak. Be careful with the compressed air can as it contains harmful chemicals. The faster way is to use the can of compressed air by aiming it in the cracks and blowing out the dust. There are two ways to clean in between the keys on your keyboard. A bottle of dish soap for hand washing (optional).A can of compressed air OR a screwdriver or knife for prying off the keys.A bottle of electronics cleaner or rubbing alcohol.A handkerchief, old cotton t-shirt or other cloth that will not shed fuzz.Assemble your cleaning suppliesĬleaning your keyboard doesn’t take a lot of materials, and it doesn’t take a long time to do, in most cases. Save yourself some grief by holding the keyboard over a trash can while you do this. Just flip the board over and tap gently so that the crumbs are dislodged. While you’re holding the unplugged keyboard, this is a good time to turn it upside down and knock out any loose debris, such as cookie crumbs. To further protect the electronic components of the board, you may want to cover the cable with a plastic bag or plastic wrap so that it doesn’t get wet. It’s important to unplug the keyboard before you start the cleaning process so that there’s no risk of shocking yourself. For an article with specific instructions for cleaning laptops see “How to Clean Laptop Keyboards”. Note that these instructions are for a regular computer keyboard. First of all it’s gross, and second of all it could affect your health. And while you’re sitting at your computer, you don’t want to be typing on a sticky, dusty or grimy keyboard. If you’re like a good number of Americans, you sit and work at your computer most every day.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |